Hitachi DZ-MV380A Owners Guide - Page 50
Recording Movie
View all Hitachi DZ-MV380A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
Recording Movie Insert a recordable DVD-RAM or DVD-R disc into this DVD video camera/recorder. ACCESS/PC indicator Pressing REC once will start recording; pressing it once again will temporarily stop recording. Power switch 1 Turn the DVD camera/recorder on. Set the power switch to " VIDEO" to turn the DVD video camera/recorder on. After the ACCESS/PC indicator goes out, perform the subsequent operation: 2 Check the subject on the screen (viewfinder or LCD). If using the viewfinder, pull it out. 3 Press the REC button. The " " mark in the viewfinder or on the LCD screen will change to the " " mark, and recording will start. During recording, the recording indicator on the front of DVD video camera/recorder will light. Pressing REC again during recording will set the DVD video camera/recorder to the recording pause status. 4 When recording is finished, turn the DVD video camera/recorder off. Note: • See page 147 when recording movie is not possible. • See page 147 if it takes some time before recording is possible. • See page 62 for on-screen information display. • It is recommended that you use DVD-RAM disc from which recorded contents can be deleted. • Sound is recorded from the stereo microphone on the front of DVD video camera/recorder: Take care that this microphone is not blocked. • You can press the REC button immediately after the DVD video camera/recorder enters the recording pause status, but no further recording can be made while "DISC ACCESS" is being displayed Recording will restart after the message disappears. • Take care that power is not interrupted while the ACCESS/PC indicator is blinking. • The minimum recordable time of movie is approximately 3 seconds. • See page 93 for setting of Record LED (recording indicator) On/Off. • For various functions available during recording, see "Setting Up Camera Functions" on page 80. • Hitachi cannot be responsible for video and audio that cannot be recorded or edited because of any defect. • The power switch can be changed over even during recording, but the operation will not be changed. • Each time the DVD video camera/recorder enters the recording pause status, the counter display will be reset to "0:00:00". • When using DVD-R disc, do not perform the following, or data on the disc may not be read: - Using another device, doing additional recording on DVD-R disc recorded on this DVD video camera/ recorder - Using this DVD video camera/recorder, doing additional recording on DVD-R disc recorded on another device English 50