Hoover UH30065 Manual - Page 13
Agitator brush roll
View all Hoover UH30065 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Agitator brush roll Check agitator brush roll When agitator brush roll brushes are worn, the agitator brush roll should be replaced. To check condition of brushes, turn cleaner OFF and disconnect from electrical outlet. ® What to buy When purchasing a new agitator brush roll, ask for HOOVER part no. 48414140. How to replace Turn cleaner ON and rotate mode control dial to HARD FLOOR. Turn cleaner OFF and disconnect from electrical outlet. Place handle in upright position and turn cleaner over so bottom side is up. B A 41 Remove the five screws as shown with a Phillips screwdriver. Lift off bottom plate (A). 40 Move edge of a card across bot- tom plate while turning agitator brush roll. To maintain cleaning effectiveness, replace agitator brush roll if brushes do not touch card. C E D 42 Pull up on agitator brush roll (C) to remove from brush roll cavity. 43 Holding agitator brush roll with one hand, slide belt (D) off the agitator brush roll. NOTE: Hold on to the belt with one hand. Do not allow the belt to fall back into the cavity on bottom of cleaner. 44 Hold new agitator brush roll in one hand; the belt in the other. Slide the belt onto the agitator brush roll, positioning the belt in the belt guide (E) on the agitator brush roll. (Cont'd) ¡ 13