Hoover UH30065 Manual - Page 9
Cleaning lightweight, flexible rugs, Edge cleaning, Using the tools, Select proper tool, Attach
View all Hoover UH30065 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
® Cleaning lightweight flexible rugs 21 Stand on one end of rug and move cleaner toward other end. Before reaching edge, push down on handle. This will lift up the nozzle and will prevent the rug from clinging to the cleaner. Continue to lift up nozzle so that when you have reached the edge, it is completely off the rug. Move cleaner back to start again, lower nozzle, and use only forward strokes. Using the tools Tools allow for cleaning surfaces above the floor and for reaching hard to clean areas. The cleaner is ready for tool use when the handle is in the upright position. Note: When handle is in upright position, agitator brush roll is automatically OFF. Edge cleaning 22 Special edge groomers are provid- ed on both sides of the front of the cleaner to remove dirt in carpet near baseboards and furniture. Guide either side parallel to the edge of carpet or furniture. Attach tools Select proper tool B A C E D 23 Select the proper tool for the cleaning task. A. Dusting brush use for carved furniture, table tops, books, lamps, lighting fixtures, venetian blinds, baseboards, shutters, and registers. B. Furniture nozzle use for upholstered furniture, draperies, mattresses, clothing, automobile interiors, and carpeted stairs. C. Powered pet hair cleaning tool use for upholstered furniture, carpeted stairs and hard to reach places. D. Crevice tool use in tight spaces, corners and along edges in such places as dresser drawers, upholstered furniture, stairs, and baseboards. E. Soft Touch™ floor brush (some models) use on hard surface floors. F G 24 F. Telescoping handle/wand can be extended by depressing the button (G) and pulling wand outward. Release button to lock into position. Shorten the telescoping handle/wand by depressing the button and pulling wand back. 25 All tools attach in the same manner. Tools may be attached to the telescoping handle/wand or directly to the hose (see Fig. 26). 26 Attach tool to wand or hose by pushing it firmly onto the end of the wand or hose. Twist tool slightly to tighten or loosen the connection. For optimum performance of the powered pet hair cleaning tool, attach it directly to the hose. The hose can be removed from the handle grip by depressing the button and pulling away from the wand. ¡ (Fig. 5) (Cont'd) 09