Husqvarna AUTOMOWER 430XH Owner Manual - Page 19
To examine where to put the guide
![]() |
View all Husqvarna AUTOMOWER 430XH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
B 0 cm / 0" A CAUTION: Do not put a section of • Put the boundary wire around the secondary boundary wire across the other. area (B) to make an island. Refer to To The sections of boundary wire make an island on page 18. must be parallel. Note: The boundary wire must be put as 1 loop around all of the work area (A + B). CAUTION: Do not put the guide wire across the boundary wire, for example a boundary wire that goes to an island. Note: When the product cuts grass in the secondary area, the Secondary area mode must be selected. Refer to Secondary area on page 34. 3.3.3.4 To make a secondary area Make a secondary area (B) if the work area has 2 areas that are not connected with a passage. The work area with the charging station is the main area (A). Note: The product must be manually moved between the main area and the secondary area. 3.3.4 To examine where to put the guide wire • Put the guide wire in a line at a minimum of 2 m / 7 ft. in front of the charging station. • Make sure that the guide wire has as much free area as possible to the left of the guide wire when facing the charging station. Refer to To set the corridor width on page 29. • Put the guide wire minimum 30 cm / 12 in. from the boundary wire. • Do not make sharp bends when you install the guide wire. • If the work area has a slope, put the guide wire diagonally across the slope. 1230 - 001 - Installation - 19
![](/manual_guide/products/husqvarna-automower-430xh-owner-manual-c6dbe85/19.png)