Husqvarna AUTOMOWER 430XH Owner Manual - Page 46
Weak GPS signal
![]() |
View all Husqvarna AUTOMOWER 430XH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Message Guide 1 not found Guide 2 not found Guide 3 not found Cause The guide wire is not connected to the charging station. Break in the guide wire. Action Check that the guide wire's connector is tightly connected to the charging station. Refer to To install the guide wire on page 21. Find out where the break is. Replace the damaged section of the guide wire with a new loop wire and splice using an original coupler. The guide wire is not connected to the boundary loop. Check that the guide wire is connected correctly to the boundary loop. Refer to To install the guide wire on page 21. Guide calibration failed The product has failed to calibrate the guide wire. Check that the guide wires are installed according to the instructions. Refer to To install the guide wire on page 21. Guide calibration The product has succeeded to calibrate No action required. accomplished the guide wire. GPS navigation problem Problem with the GPS assisted naviga- Contact your local Husqvarna repre- tion equipment. sentative if this message appears of- ten. Weak GPS signal The GPS signal is weak for the current work area. GPS assisted navigation cannot be used. If the message appears often, disable the GPS assisted navigation and instead use the manual settings for Lawn coverage. Refer to To disable and enable the GPS function on page 27. Difficult finding home The product has been following the The installation has not been done cor- boundary wire several laps without find- rectly. Refer to Installation on page 16. ing the charging station. Wrong corridor width setting on boun- dary wire. Refer to To set the corridor width on page 29. The product was started on a Secondary area with the Main area setting. Temporary prob- Please try again. lem with the server. Contact your local Husqvarna representative if this message appears often. Connection problems Problem with the Automower® Connect module Restart the product. If there still is a connection problem, try to unpair the product (My mowers) and then pair it again. If the problem remains, contact your local Husqvarna representative. Connection settings restored Settings for wireless connectivity have Check and revise settings if necessary. been restored due to an error. 46 - Troubleshooting 1230 - 001 -
![](/manual_guide/products/husqvarna-automower-430xh-owner-manual-c6dbe85/46.png)