IBM 4910-33D Installation Guide - Page 30
Removing and installing the flash drive, with the white plastic guide pin
View all IBM 4910-33D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Removing and installing the flash drive 1 March 2009 2 Figure 9. Removing the flash drive To remove the flash drive or to access the system board to install a flash drive: 1. Open the unit. See "Removing and installing the top cover" on page 12. 2. If present, remove the hard drive tray assembly. See "Removing and installing the hard disk drive and hard disk tray as an assembly" on page 15. 3. To remove the flash drive, gently lift the flash drive 1 straight up and off the white plastic guide pin 2 . To replace or install a flash drive: 1. Align the flash drive 1 with the white plastic guide pin 2 and with the connectors on the system board. Push down until the flash drive is seated. 2. Replace the hard drive tray assembly. See "Removing and installing the hard disk drive and hard disk tray as an assembly" on page 15 3. Replace the top cover. See "Removing and installing the top cover" on page 12. 16 SurePOS Installation and Service