IBM 4910-33D Installation Guide - Page 33

Removing and installing the I/O connector card, connector-card retainer outward to the open position

Get IBM 4910-33D PDF manuals and user guides View all IBM 4910-33D manuals
Add to My Manuals
Save this manual to your list of manuals

Page 33 highlights

March 2009 Removing and installing the I/O connector card 2 1 3 Figure 15. Removing the I/O connector card To remove the I/O connector card: 1. Open the unit. See "Removing and installing the top cover" on page 12. 2. Squeeze the blue plastic connector-card retainer at the top and bottom (where the two small arrows 3 are located in Figure 15) to unlatch. Rotate the I/O connector-card retainer outward to the open position 1 as shown. 3. Slide the I/O connector card 2 out of the slot. 4. To install the I/O connector card, reverse this procedure. Note: The I/O connector card must be fully installed before the connector card latch is rotated closed. Chapter 3. Removal and installation procedures for the 4810/4910 SurePOS 300 19

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
Removing and installing the I/O connector card
To remove the I/O connector card:
1.
Open the unit. See “Removing and installing the top cover” on page 12.
2.
Squeeze the blue plastic connector-card retainer at the top and bottom (where
the two small arrows
±3²
are located in Figure 15) to unlatch. Rotate the I/O
connector-card retainer outward to the open position
±1²
as shown.
3.
Slide the I/O connector card
±2²
out of the slot.
4.
To install the I/O connector card, reverse this procedure.
Note:
The I/O connector card must be fully installed before the connector card
latch is rotated closed.
1
2
3
Figure 15. Removing the I/O connector card
March 2009
Chapter 3. Removal and installation procedures for the 4810/4910 SurePOS 300
19