IBM 865511Y Hardware Maintenance Manual - Page 19

Error Messages Specific to the Integrated Ethernet Subsystem Note The error messages shown in this section are available only with the integrated Ethernet subsystem. These error messages are not available when RPL (remote program load) or DHCP (dynamic host configuration protocol) is used through optional network adapters. If a failure condition occurs after the Ethernet controller is initialized, an error message appears on the screen. The error messages that can occur are shown below. If you experience any error related to the integrated Ethernet subsystem, record the error message, and tell your network administrator about the problem. RPL-Related Error Messages: These error messages are specific to the integrated Ethernet controller and the RPL environment of your computer. The two most common error messages are shown below. RPL-ROM-ERR: 1 5 The integrated Ethernet failed the loopback test. RPL-ROM-ERR: 1 7 Media test failed; check the cable. Error 105 indicates that a power-on diagnostic test performed by the Ethernet module did not execute correctly. If this error message appears, you must have the computer serviced. Error 107 indicates that the cable from the LAN is not securely connected to the Ethernet port on your computer. Check the cable to ensure that it is properly connected. Other error messages that might occur are shown in the following table. RPL-ROM-ERR: 100 The integrated Ethernet cannot be found. RPL-ROM-ERR: 101 The integrated Ethernet was unable to initialize. RPL-ROM-ERR: 102 The integrated Ethernet could not be reset. RPL-ROM-ERR: 103 There are multiple Ethernets in the system. Specify the correct serial number in NET.CFG. RPL-ROM-ERR: 104 The integrated Ethernet EEPROM is faulty or not present. RPL-ROM-ERR: 106 The integrated Ethernet is configured for Plug and Play in non-Plug and Play system. RPL-ROM-ERR: 110 The integrated Ethernet RAM failed the memory test. Netfinity 8655 - Type 8655 11