IBM IC35L040AVVN07-0 Hard Drive Specifications - Page 184
Off-line Data Collection Status, 33.2.4, Self-test execution status
UPC - 683728124212
View all IBM IC35L040AVVN07-0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 184 highlights
Status Flag definitions Bit Definition 0 Pre-failure/advisory bit 0 An attribute value less than or equal to its corresponding attribute threshold indicates an advisory condition where the usage or age of the device has exceeded its intended design life period. 1 An attribute value less than or equal to its corresponding attribute threshold indicates a pre-Failure condition where imminent loss of data is being predicted. 1 On-line Collective bit 0 The attribute value is updated only during Off-line testing. 1 The attribute value is updated during On-line testing or during both On-line and Off-line testing. 2 - 5 Vendor specific 6 - 15 Reserved (0) Normalized values The device performs conversion of the raw attribute values to transform them into normalized values, which the host can then compare with the threshold values. A threshold is the excursion limit for a normalized attribute value. 11.33.2.3 Off-line Data Collection Status The value of this byte defines the current status of the off-line activities of the device. Bit 7 indicates Automatic Off-line Data Collection Status. Bit 7 1 0 Automatic Off-line Data Collection Status Automatic Off-line Data Collection is enabled Automatic Off-line Data Collection is disabled Bits 0 thru 6 represents a hexadecimal status value reported by the device. Value 0 2 4 5 6 Definition Off-line data collection never started All segments completed without errors Off-line data collecting suspended by interrupting command Off-line data collecting aborted by interrupting command Off-line data collection aborted with fatal error 11.33.2.4 Self-test execution status Bit Definition 0-3 Percent Self-test remaining. An approximate percentage of the self-test routine remain- ing until completion; given in ten percent increments. Valid values are 0 through 9 4-7 Current Self-test execution status 0 The self-test routine completed without error or has not been run 1 The self-test routine aborted by the host 2 The self-test routine interrupted by the host with a hard or soft reset 3 The device was unable to complete the self-test routine due to a fatal error or to unknown test error 4 The self-test routine completed with unknown element failure 5 The self-test routine completed with electrical element failure 6 The self-test routine completed with servo element failure 7 The self-test routine completed with read element failure 15 The self-test routine in progress Deskstar 120GXP hard disk drive specifications 170