IBM IC35L040AVVN07-0 Hard Drive Specifications - Page 82
Alternate Status Register, Command Register, Cylinder High Register, Cylinder Low Register
UPC - 683728124212
View all IBM IC35L040AVVN07-0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
8.1 Alternate Status Register Alternate Status Register 7 6 BSY RDY 5 4 3 2 1 0 DF DSC/ SERV DBQ COR IDX ERR Figure 69. Alternate Status Register This register contains the same information as the Status Register. The only difference is that reading this register does not imply interrupt acknowledge or clear a pending interrupt. See 8.13, "Status Register" on page 72 for the definition of the bits in this register. 8.2 Command Register This register contains the command code being sent to the device. Command execution begins immediately after this register is written. The command set is shown in Figure 88 on page 104. All other registers required for the command must be set up before writing the Command Register. 8.3 Cylinder High Register This register contains the high order bits of the starting cylinder address for any disk access. At the end of the command this register is updated to reflect the current cylinder number. In LBA Mode this register contains Bits 16-23. At the end of the command this register is updated to reflect the current LBA Bits 16-23. The cylinder number may range from zero to the number of cylinders minus one. 8.4 Cylinder Low Register This register contains the low order bits of the starting cylinder address for any disk access. At the end of the command this register is updated to reflect the current cylinder number. In LBA Mode this register contains Bits 8-15. At the end of the command this register is updated to reflect the current LBA Bits 8-15. The cylinder number may be from zero to the number of cylinders minus one. Deskstar 120GXP hard disk drive specifications 68