Icom IC-2820H Instruction Manual - Page 74
Message Transmission
View all Icom IC-2820H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
5 DV MODE OPERATION (Optional UT-123 is required) D Message Transmission Select the message transmission function ON (Ch01-05) and OFF. When a message channel is selected, the transceiver transmits a text message (pre-programmed). (default: OFF) q Push [F• ] twice to display the function guide 2. wPush [MSG](LOW•PRIO) to display the "MESSAGE" screen. eRotate [DIAL] to select "TX MESSAGE," then push [MAIN•BAND]. r Rotate [DIAL] to select the desired message channel. • "Ch01" to "Ch05" available. • See page 52 for message programming. t Push [BACK](V/MHz•SCAN) (Right band's) to set the message for transmission. y Push [BACK](V/MHz•SCAN) (Right band's) again to return to function guide 2 indication. uPush [PTT] to transmit the selected message. • The message is transmitted each time [PTT] is pushed. • The message is transmitted each 30 sec. automatically during continuous transmission. i Release [PTT] to return to receive. oWhen the reply call with a message is received, the call sign and the message displays alternately at the bottom of the function display. ✔ For your information The automatic received call sign and/or message indication can be turned OFF in display set mode, if desired. ➥ RX CALL SIGN (p. 108) ➥ RX MESSAGE (p. 108) NOTE: Only 1 message can be stored in the IC-2820H. The received message is cleared by turning power OFF, or overwritten when another message is received. A transmitted message that includes lower case characters from the IC-2820H may not be decoded and displayed correctly by the ID-800H, IC-V82/U82, etc. 53