Icom IC-F5061D Operating Guide - Page 16

2 BIIS 1200 OPERATION ■ Printer connection When a printer is connected to the D-sub 25-pin connector on the transceiver, the received SDM content and the called station ID can be printed out. Ask your dealer or system operator for connection details. ■ BIIS ANI Your own ID can be transmitted each time the PTT is pushed (log-in) or released (log-off) with individual or group calls communications. When receiving an ANI, the communication log will be recorded when using a PC dispatch application. In addition, when using the ANI with log-in, the PTT side tone function can be used to inform you that the ID is sent and voice communication can be made. ■ Transmitting an Emergency call When [Emergency] (described in the instruction manual) is held down for the specified time period, an emergency signal (Status 22) is transmitted once or repeatedly* on the emergency channel. When no emergency channel is specified, the signal is transmitted on the operating channel. * W hen the Repeat Cancel function is ON, the transceiver cancels repeating after receiving an acknowledgement. When the Repeat Cancel function is OFF, the transceiver repeats calling according to the number of repeat cycles, even after receiving an acknowledgement. This function is usable in transceivers whose revision number is 3.0 or later. Ask your dealer for details. If you want to cancel the emergency call, hold down the key again before transmitting the call. The emergency call may be transmitted without a beep sounding, and the LCD display, depending on the presetting. (Silent operation) The transceiver can also be programmed to keep the microphone open during an emergency call, to allow monitoring of the situation. Ask your dealer for details. IMPORTANT: Setting a separate emergency channel to provide reliable emergency call operation is recommended. 13