Icom IC-M506 Instruction Manual - Page 115
DMB-132 installation, Attach the clamps on either side of the transceiver with 2
View all Icom IC-M506 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 115 highlights
CONNECTIONS AND MAINTENANCE 12 r Locking nut e End bolt D MB-132 installation q A ttach the clamps on either side of the transceiver with 2 supplied bolts. (M5 × 8 mm) • Make sure that the clamps align parallel to the transceiver body. 1 w T ighten the end bolts on the clamps (clockwise) so that the 2 clamps press firmly against the inside of the instrument 3 control panel. e Tighten the locking nuts (counterclockwise) so that the trans- 4 ceiver is securely mounted in position, as shown below. r C onnect the antenna and power cable, then return the in- 5 strument control panel to its original place. 6 7 8 e 9 10 w 11 12 13 14 15 16 106
106
12
CONNECTIONS AND MAINTENANCE
e
End bolt
Locking nut
r
D
MB-132 installation
q
Attach the clamps on either side of the transceiver with 2
supplied bolts. (M5 × 8 mm)
• Make sure that the clamps align parallel to the transceiver body.
w
Tighten the end bolts on the clamps (clockwise) so that the
clamps press firmly against the inside of the instrument
control panel.
e
Tighten the locking nuts (counterclockwise) so that the trans-
ceiver is securely mounted in position, as shown below.
r
Connect the antenna and power cable, then return the in-
strument control panel to its original place.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
w
e