Icom IC-M506 Instruction Manual - Page 116
Microphone installation, Installation
View all Icom IC-M506 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 116 highlights
12 CONNECTIONS AND MAINTENANCE ■■Microphone installation eeUsing the mounting base as a template, carefully mark the holes where the cable and three screws will be fastened. rrDrill holes at these marks. ttInstall the mounting base using the supplied screws, as shown below. Mounting base Nut The optional HM-195 should be connected to the transceiver using the supplied OPC-1540 connection cable. The cable is used to operate from a longer distance. The cable connector can also be installed as a built-in plug on a cabinet or wall. To operate from even longer distances, the optional 6 meter long OPC-1541 extension cable can be used between the transceiver and the OPC-1540. Up to two OPC-1541 can be added. DDInstallation qqInsert the OPC-1540 cable connector into the command microphone jack, and tighten the nut. wwTo use the cable connector as a wall socket, install it as described to the right. 107 Gasket Screw holes (approx. 2 (d) mm; 3⁄32˝) Cap yyThe completed installation should look like this.