InSinkErator Invite H990-SS Owners Manual - Page 10
Mounting The Tank, Connecting Faucet To Tank
View all InSinkErator Invite H990-SS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
3 MOUNTING THE TANK A I Select a spot under the sink to mount Tank must be mounted level to ensure proper operation. tank vertically within reach of both plumbing and electrical connections. The tank should be within 16" or less of faucet water lines and within 30" or less of a standard grounded outlet. Property Damage: Tank must be located within 16" of faucet and within 30" or less of a standard grounded outlet. DO NOT extend plumbing or electrical lines. I While holding tank in place on the spot selected for installation, use a pencil to mark locations for 2 hanging screws. B Leave 1/4" for hanging tank. Mount tank vertically in an area that allows clearance on the underside of the tank for drainage, if necessary. DO NOT over tighten screws. Screws provided are for use in wood studs or cabinets only. Use wall anchors (not supplied) for installation into drywall. I Pre-drill 1/8" pilot holes at marks. I Turn screws into pre-drilled holes, leaving 1/4" exposed. I Hang the tank on the screws. I Tighten the screws with only 1/2 turn clockwise. 4 CONNECTING FAUCET TO TANK A I Without depressing the gray button, place the snap-connect fitting at (1) (2) (3) the end of the blue 1/4" tube onto the left fitting on the tank, pushing until it clicks into place. (1) I Slip the flexible white 7/16" tube over barbed middle fitting and slide down approximately 1/2". (2) I Slip the clear 5/16" tube over the far right smooth fitting and slide down approximately 1/2". (3) Property Damage: Pinched or blocked water lines may cause damage to the dispenser tank. Property Damage: Check to make sure tubes are connected properly and are pushed down as far as possible. I Visually check for pinched or crimped tubes. Hose clamps are not needed for any of the connections. 10