InSinkErator Invite H990-SS Owners Manual - Page 9

Installing The Faucet - H770

Get InSinkErator Invite H990-SS PDF manuals and user guides View all InSinkErator Invite H990-SS manuals
Add to My Manuals
Save this manual to your list of manuals

Page 9 highlights

2 INSTALLING THE FAUCET - H770 A H770 I Unpack dispenser components. I On a firm, flat surface, carefully straighten the copper tubing using hands only. Property Damage: Do not pinch or break copper tubing. Do not distort the last 1 inch of tubing. B Fiber Gasket Make sure to use fiber gasket to ensure proper seal. H770 I Ensure that the fiber gasket is properly seated against the base of the dispenser head. DO NOT remove mounting screw or fiber gasket from base of dispenser. C An assistant may be needed to hold the dispenser head in place while securing the dispenser. H770 I Feed tubes down the hole in the sink or countertop until the base is at rest on the sink or countertop surface. I Position faucet head at the desired angle. D Half moon shaped metal mounting plate should cradle all descending tubes. H770 I From below the sink, place semicircular metal mounting plate over the mounting screw, ensuring the mounting plate covers the sink hole. I Slide washer over so that the screw is now inside the smaller hole. Tighten the screw until snug. 9

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
Property Damage:
Do not pinch or
b
reak copper
t
ub
in
g
. Do not
d
i
s
tort the la
s
t 1 inch of t
ub
in
g
.
Make sure to use fiber gasket
to ensure proper seal.
■
Unpack dispenser components.
■
On a firm, flat surface, carefully
straighten the copper tubing using
hands only.
■
Ensure that the fiber gasket is
properly seated against the base
of the dispenser head.
2
B
A
Fiber
Gasket
H770
H770
■
From below the sink, place semi-
circular metal mounting plate over
the mounting screw, ensuring the
mounting plate covers the sink hole.
■
Slide washer over so that the screw
is now inside the smaller hole.
Tighten the screw until snug.
■
Feed tubes down the hole in the sink
or countertop until the base is at rest
on the sink or countertop surface.
■
Position faucet head at the
desired angle.
Half moon shaped metal mounting plate
should cradle all descending tubes.
An assistant may be needed to hold
the dispenser head in place
while securing the dispenser.
C
D
H770
H770
DO NOT remove mounting screw or
fiber gasket from base of dispenser.
9
INSTALLING THE FAUCET - H770