InSinkErator Invite H990-SS Owners Manual - Page 14
Troubleshooting
View all InSinkErator Invite H990-SS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Please read Troubleshooting Guide and/or visit www.insinkerator.com before calling AnswerLine™ TROUBLESHOOTING PROBLEM Water and steam spits forcefully from spout without turning on the dispenser faucet. POSSIBLE CAUSE • Unit is boiling. May be normal during initial setup. WHAT TO DO • Activate faucet lever to release some water from the tank. • Adjust water temperature using dial on tank front. Remember that at higher altitudes, water boils at lower temperatures. Water is not hot. • The unit is unplugged. • The electric outlet is inoperative. • Make sure the unit is connected to a properly grounded electric outlet. • Make sure the circuit breaker or fuses are functioning properly. • Check that the outlet is not switched off. Water is too hot or not hot enough. • Thermostat is not adjusted to your needs. • Adjust the thermostat slowly, then activate faucet lever for 20 seconds to bring in fresh water to be heated at the new setting. Allow 5-7 minutes for water to reach new temperature. Water comes out the vent instead of spout. • Outlet tube is blocked. • Check that outlet tube is not kinked, twisted or pinched. • Unscrew spout end piece and clean out any debris. Water is dripping from the spout/vent intermittently. • The expansion chamber isn't draining properly due to low water pressure. • The spout is blocked. • Unplug the unit. If the dripping doesn't stop after a few minutes, check the supply valve to ensure that is fully open and there are no obstructions in the water line reducing the pressure below 30 psi (i.e., a poorly mounted saddle valve, a clogged water filter, or a partially opened shut-off valve). • Unscrew spout end piece and clean out any debris. Water is dripping from the spout/vent constantly. • Debris in the water line may be in the faucet valve seat causing a slow water leak. • Unscrew spout end piece and clean out any debris. • Activate faucet lever 7-10 times to flush faucet & lines. Divided stream. • Debris in the end piece. • Unscrew spout end piece and clean out any debris. Water continues to run • Mounting nut too tight. after releasing lever. (HC3/GN3/View/ Wave) • Mounting washers not installed properly • Loosen mounting nut, 1/4 turn at a time, until shut-off occurs. • See page 6 or 7, Step 2B to check proper mounting washer installation. If you are still experiencing trouble call the AnswerLine™ 1-800-558-5700. 14