Intel AFCSASRISER User Guide - Page 186

Table 14. MFI Messages Number Type 0 Info 1 Info 2 Fatal 3 Info 4 Info 5 Warning 6 Info 7 Info 8 Info 9 Info 10 Fatal 11 Fatal 12 Info 13 Fatal 14 Info 15 Dead 16 Info 17 Info 18 Critical 19 Critical 20 Critical 21 Info 22 Info 23 Critical 24 Critical 25 Critical 26 Critical 27 Critical 28 Info 29 Info 30 Info 31 Info 32 Dead 33 Warning 34 Dead 35 Info 36 Info 37 Info 38 Info 39 Info 40 Info Description Firmware initialization started (PCI ID %04x/%04x/%04x/%04x) Firmware version %s Unable to recover cache data from TBBU Cache data recovered from TBBU successfully Configuration cleared Cluster down; communication with peer lost Virtual drive %s ownership changed from %02x to %02x Alarm disabled by user Alarm enabled by user Background initialization rate changed to %d%% Controller cache discarded due to memory/battery problems Unable to recover cache data due to configuration mismatch Cache data recovered successfully Controller cache discarded due to firmware version incompatibility Consistency Check rate changed to %d%% Fatal firmware error: %s Factory defaults restored Flash downloaded image corrupt Flash erase error Flash timeout during erase Flash error Flashing image: %s Flash of new firmware image(s) complete Flash programming error Flash timeout during programming Flash chip type unknown Flash command set unknown Flash verify failure Flush rate changed to %d seconds Hibernate command received from host Event log cleared Event log wrapped Multi-bit ECC error: ECAR=%x Single-bit ECC error: ECAR=%x Not enough controller memory Patrol Read complete Patrol Read paused Patrol Read Rate changed to %d%% Patrol Read resumed Patrol Read started Rebuild rate changed to %d%% 174 Intel® RAID Software User's Guide