Intel WX58BP Product Guide - Page 64
A Error Messages and Indicators - memory problems
UPC - 735858208864
View all Intel WX58BP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
A Error Messages and Indicators Intel® Workstation Board WX58BP reports POST errors in two ways: By sounding a beep code By displaying an error message on the monitor BIOS Beep Codes The BIOS also issues a beep code (one long tone followed by two short tones) during POST if the video configuration fails (a faulty video card or no card installed) or if an external ROM module does not properly checksum to zero. Table 13 lists the BIOS codes. Beep 3 Siren Table 13. Beep Codes Description No memory Processor overheat (on reboot) BIOS Error Messages When a recoverable error occurs during the POST, the BIOS displays an error message describing the problem. Table 14 gives an explanation of the BIOS error messages. Table 14. BIOS Error Messages Error Message PROCESSOR_THERMAL_TRIP_ERROR MULTI_BIT_ECC_ERROR SINGLE_BIT_ECC_ERROR CMOS_BATTERY_ERROR CMOS_CHECKSUM_ERROR CMOS_TIMER_ERROR MEMORY_SIZE_DECREASE_ERROR INTRUDER_DETECTION_ERROR SPD_TOLER_ERROR MEM_OPTIMAL_ERROR Explanation Processor was previously shut down due to a thermal event (overheating). The firmware detected a Multi-Bit ECC Error occurred. The firmware detected a Single-Bit ECC Error occurred. The firmware detected a CMOS battery failure occurred. The firmware detected a CMOS Checksum Error occurred. The firmware detected the system date/time has not been set. The firmware detected the system memory has decreased. The system chassis was opened. SERIAL PRESENCE DETECT (SPD) device data missing or inconclusive. Properly programmed SPD device data is required for reliable operation. The installed amount of memory in Channel A is not equal to the amount of memory in Channel B. Maximum memory performance is achieved with equal amounts of memory installed in each channel. 64