Invacare IN66AHANFR Owners Manual - Page 31
Adjusting Quick-Release Axle
View all Invacare IN66AHANFR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
DETAIL "A" Rear Wheel SECTION 7-REAR WHEELS DETAIL "B" Quick Release Axle Rear Wheel Quick Release Axle Button Quick Release Axle Button DETAIL "C" Rear Wheel Wheelchair Frame Axle Lug DETAIL "D" Quick-Release Axle Detent Balls (See FIGURE 7.2) FIGURE 7.1 Removing/Installing Rear Wheels - Removing Adjusting Quick-Release Axle ƽ WARNING Make sure detent pin and detent balls of the quick-release axles are fully released before operating the wheelchair. Keep detent balls clean. NOTE: For this procedure, refer to FIGURE 7.1 and FIGURE 7.2 on page 32. 1. Push in the quick release axle button and pull the quick release axle with rear wheel out of the axle lug in the wheelchair frame (FIGURE 7.1). 2. Push in the quick release axle button again and pull the quick release axle out of the rear wheel (FIGURE 7.1). 3. Release quick release axle button and ensure that the detent balls are fully released (FIGURE 7.2). 4. Increase or decrease play by adjusting the locknut on the end of the quick‐release axle. Part No. 1163197 31 Insignia™