JVC DVL120U Instruction Manual - Page 28

28 EN SNAPSHOT Button Lock Button Power Switch Display SNAP MODE - FUL L P I N-UP FRAME Menu Screen FULL Snapshot mode with no frame PIN-UP Pin-Up mode FRAME Snapshot mode with frame There is the sound effect of a shutter closing. FOR RECORDING (cont.) Snapshot This feature lets you record still images that look like photographs onto a tape. SNAPSHOT MODE SELECTION 1 Set the Power Switch to " " while pressing down the Lock Button located on the switch. 2 Press the MENU/BRIGHT wheel in. The Menu Screen appears. 3 Rotate the MENU/BRIGHT wheel to select " CAMERA". Press it and the CAMERA Menu appears. 4 Rotate the MENU/BRIGHT wheel to select "SNAP MODE", then press it. 5 Rotate the MENU/BRIGHT wheel to select the desired Snapshot mode, then press it. Rotate the MENU/BRIGHT wheel to select " RETURN" and press it twice. The Menu Screen closes. SNAPSHOT RECORDING 1 Press SNAPSHOT. "PHOTO" appears while the snapshot is being taken. If you press during Record-Standby PHOTO" appears and a still image will be recorded for approx. 6 seconds, then the camcorder re-enters the Record-Standby mode. If you press during Recording PHOTO" appears and a still image will be recorded for approx. 6 seconds, then the normal recording resumes. • Regardless of the Power Switch position (" " or " "), Snapshot recording takes place using the selected Snapshot mode. Motor Drive Mode Keeping SNAPSHOT pressed provides an effect similar to serial photography. (Interval between still images: approx. 1 second) NOTES: ● To remove the shutter sound, ੬ "BEEP" on pg. 32, 34. ● If Snapshot recording is not possible, "PHOTO" blinks when SNAPSHOT is pressed. ● If Programme AE with special effects (੬ pg. 24) is engaged, certain modes of Program AE with special effects are disabled during Snapshot recording. In such a case, the icon blinks. ● If SNAPSHOT is pressed when "DIS" is set to "ON" (੬ pg. 33), the Stabiliser will be disabled. ● During playback as well, all Snapshot modes are available. The shutter sound is not heard. ● During Snapshot recording, the image displayed in the viewfinder may be partially missing. However, there is no effect in the recorded image. ● When a cable is connected to the AV connector, the shutter sound is not heard from the speaker, however it is recorded onto the tape.