JVC DVL120U Instruction Manual - Page 44

44 EN USING THE OPTIONAL REMOTE CONTROL UNIT (cont.) Lock Button Power Switch Display 6w 12: 34 Remote sensor START/STOP Insert Editing You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in and outpoints. The original audio remains unchanged. NOTES: ● Before performing the following steps, make sure that "TIME CODE" is set to "ON" in the Menu Screen (੬ pg. 35, 37). ● Insert Editing is not possible on a tape recorded in the LP mode or on a blank portion of a tape. ● To perform Insert Editing while watching in the television, make connections (੬ pg. 20). 1 Play back the tape, locate the Edit-Out point and press PAUSE (6). Confirm the time code at this point (੬ pg. 35, 37). 2 Press REW (2) until the Edit-In point is located, then press PAUSE (6). 3 Press and hold INSERT (w) on the remote control, then press PAUSE (6). "6w" and the Time Code (min.:sec.) appear and the camcorder enters Insert-Pause mode. 4 Press START/STOP to begin editing. • Confirm the insert at the time code you checked in step 1. • To pause editing, press START/STOP. Press it again to resume editing. 5 To end Insert Editing, press START/STOP, then STOP (5). NOTES: ● Programme AE with special effects (੬ pg. 24, 25) can be used to spice up the scenes being edited during Insert Editing. ● During Insert Editing, the date and time information changes. ● If you perform Insert Editing onto a blank space on the tape, the audio and video may be disrupted. Make sure you only edit recorded areas. ● During Insert Editing, when the tape moves to scenes recorded in the LP mode or a blank portion, Insert Edting stops (੬ pg. 62). REW PAUSE PLAY STOP INSERT RM-V700U (optional)