JVC DVL120U Instruction Manual - Page 6

6 EN How To Attach The Core Filter Attach the Core Filter(s) (if provided with your model ੬ pg. 5) to an optional cable(s). The Core Filter reduces interference. 1 2 3 3 cm Stopper Release the stoppers on both ends of the Core Filter. Wind once Run the cable through the Core Filter, leaving approx. 3 cm of cable between the cable plug and the Core Filter. Wind the cable once around the outside of the Core Filter as shown in the illustration. • Wind the cable so that it is not slack. NOTE: Take care not to damage the cable. Close the Core Filter until it clicks shut. Ⅲ When connecting cables, attach the end with the Core Filter to the camcorder. AUTOMATIC DEMONSTRATION Automatic Demonstration takes place when "DEMO MODE" is set to "ON" (factory-preset). Ⅲ Automatic Demonstration starts when there is no operation for about 3 minutes after the Power Switch is set to " " or " " and no cassette is in the camcorder. Ⅲ Performing any operation during the demonstration stops the demonstration temporarily. If no operation is performed for more than 3 minutes after that, the demonstration will resume. Ⅲ "DEMO MODE" remains "ON" even if the camcorder power is turned off. Ⅲ To cancel Automatic Demonstration: 1. Set the Power Switch to " " while pressing down the Lock Button located on the switch and press the MENU/BRIGHT wheel in. The Menu Screen appears. 2. Rotate the MENU/BRIGHT wheel to select " SYSTEM" and press it. The SYSTEM Menu appears. 3. Rotate the MENU/BRIGHT wheel to select "DEMO MODE" and press it. The Sub Menu appears. 4. Rotate the MENU/BRIGHT wheel to select "OFF" and press it. 5. Rotate the MENU/BRIGHT wheel to select " RETURN", and press it twice. The normal screen appears. MENU/BRIGHT Wheel Lock Button Power Switch Sub Menu DEMO MODE - OF F ON NOTE: If you do not detach the Lens Cap, you cannot see the actual changes of the Automatic Demonstration activated on the LCD monitor or viewfinder.