JVC GR-SXM260 Instruction Manual - Page 42

42 EN USING THE REMOTE CONTROL UNIT (cont.) Insert Editing You can record a new scene onto a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in- and out-points. The original audio remains unchanged. NOTE: Use the remote control unit to perform this procedure. 1 Set the Power Switch to "PLAY". Power Switch COUNTER R/M Button Display w M- 0 : 1 2 : 3 4 Insert editing indicator Tape Counter 2 Play back the tape, locate the Edit-Out point and press PAUSE (6). 3 Press and hold COUNTER R/M on the camcorder for more than 1 second to reset the tape counter, then press it again for less than 1 second so that "M" appears. 4 Press REW (2) to go a little beyond the beginning of the scene you want to replace, press PLAY (4) to view the recorded tape, and press PAUSE (6) exactly at the Edit-In point where the new scene should start. Remote sensor 5 Press and hold INSERT (w), and without releasing INSERT (w), press and release PAUSE (6). The Insert Editing indicator appears and the Insert Editing mode is engaged. When the scene the camcorder is aimed at appears on the screen, go to the next step. 6 To begin Insert Editing, press START/STOP. When the counter reaches "0:00:00", editing stops automatically and the camcorder enters the Insert-Pause mode. 7 To end Insert Editing, press STOP (5). START/STOP REW INSERT PLAY PAUSE STOP RM-V716U (provided with OR GR-SXM460A/ SXM46EA only) RM-V700U (optional) NOTES: ● During Insert Editing, the original audio will be heard from the speaker. ● After step 5, Retake (੬ pg. 19) can be performed. ● The tape may stop slightly before or after the designated end point, and noise bars may appear. Neither indicates a defect in the unit. ● Only the video signal is recorded in the Insert Editing mode. ● If Programme AE (੬ pg. 23) is set during Insert Editing, press and hold P. AE for more than 1 second.