JVC GR-SXM260 Instruction Manual - Page 46

46 EN USING THE REMOTE CONTROL UNIT (cont.) Power Switch SELECT SCENES 4 Point the remote control at the camcorder's remote sensor. Press PLAY (4), then press R.A.EDIT ON/OFF (RM-V716U)/ON/OFF (RM-V700U) on the remote control. The R.A. Edit counter display appears. Remote sensor 5 Press REW (2) or FF (3) to locate the beginning of the scene you want, then press EDIT IN/OUT (RMV716U)/IN/OUT (RM-V700U) to register that point. The data appears under "IN" on the display. 6 Press REW (2) or FF (3) to locate the end of the scene and press EDIT IN/OUT (RM-V716U)/IN/OUT (RM-V700U) to register it. •The data appears under "OUT" on the display. •The total time of the registered scene(s) is displayed at the bottom of the screen. 7 Repeat steps 5 and 6 for each additional scene (as many as 8). EDIT IN/OUT REW FF PLAY R.A.EDIT ON/OFF IN/OUT CANCEL ON/OFF RM-V716U (provided with OR GR-SXM460A/ SXM46EA only) RM-V700U (optional) IN OUT 1 0 : 00 : 25 2 3 4 5 6 7 8 COUN T ER 0 : 00 : 25 TOTAL 0 : 00 : 00 8 To make corrections, press CANCEL during steps 5 and 6 to erase the most recently registered point. NOTES: ● There must be at least one second between an in-point and its corresponding out-point. ● To ensure correct operation, there should be at least 15 seconds between an out-point and the next in-point. ● Blank portions of a tape cannot be registered as in-points or out-points. ● If it takes more than 5 minutes to search for an in-point, the VCR's Record-Pause mode is cancelled and editing does not take place. ● Pressing R.A.EDIT ON/OFF (RM-V716U)/ON/OFF (RM-V700U) clears all in- and out-points from memory. ● Leave a small margin for error around each in-point to ensure the scene is recorded in its entirety. ● Turning off the camcorder's power erases all registered in- and out-points. IN OUT 1 0 : 00 : 25 0 : 01 : 05 2 0 : 03 : 18 0 : 03 : 31 3 0 : 02 : 33 0 : 02 : 53 4 0 : 04 : 11 5 6 7 8 COUN T ER 0 : 04 : 11 TOTAL 0 : 01 : 13