JVC LX-UH1B Operation Manual - Page 17

Selecting an input source

Get JVC LX-UH1B PDF manuals and user guides View all JVC LX-UH1B manuals
Add to My Manuals
Save this manual to your list of manuals

Page 17 highlights

Selecting an input source The projector can be connected to multiple equipment at the same time. However, it only displays one full screen at a time. When starting up, the projector automatically searches for the available signals. If you want the projector to always automatically search for the signals: • Go to the SYSTEM SETUP: Basic menu, and then enable Auto Input Search. (see "Auto Input Search" on page 25) To select the video source: 1. Press INPUT to display the source selection bar. 2. Press / until your desired signal is selected and press OK. Once detected, the selected source information displays on the screen for seconds. If there are multiple pieces of equipment connected to the projector, repeat steps 1-2 to search for another signal. Refer to "Projector specifications" for the native display resolution of this projector. For best display picture results, you should select and use an input signal which outputs at this resolution. Any other resolutions will be scaled by the projector depending upon the Aspect Ratio setting, which may cause some image distortion or loss of picture clarity. See "Aspect Ratio" for details. Operation 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
17
Operation
Selecting an input source
The projector can be connected to multiple equipment at the same time. However, it only
displays one full screen at a time. When starting up, the projector automatically searches for the
available signals.
If you want the projector to always automatically search for the signals:
•
Go to the
SYSTEM SETUP: Basic
menu, and then enable
Auto Input Search.
(see
"Auto
Input Search" on page 25
)
To select the video source:
1. Press
INPUT
to display the source selection bar.
2. Press
/
until your desired signal is selected and press
OK
.
Once detected, the selected source information displays on the screen for seconds. If there
are multiple pieces of equipment connected to the projector, repeat steps 1-2 to search for
another signal.
Refer to
"Projector specifications"
for the native display resolution of this projector. For best display
picture results, you should select and use an input signal which outputs at this resolution. Any other
resolutions will be scaled by the projector depending upon the Aspect Ratio setting, which may cause
some image distortion or loss of picture clarity. See
"Aspect Ratio"
for details.