JVC LX-UH1B Operation Manual - Page 24

Submenu e-shift Functions and Descriptions Switches the display resolution. • Off: Switches to 2K resolution. Picture Mode will automatically be set to fixed mode. • On (recommended): Switches to 4K resolution. INSTALLATION menu Submenu Functions and Descriptions Projector Mode See "Choosing a location" for details. Test Pattern Is used to adjust the image size and focus and check that the projected image is free from distortion. To close the test pattern, go back to this menu and select Off. Lamp Settings 12V Trigger • Lamp Mode Select the projector lamp power from the following modes. • Normal: Provides full lamp brightness. • Eco: Reduces system noise and lamp power consumption by 30%. If the Eco mode is selected, the light output will be reduced and result in darker projected pictures. See "Setting Lamp Mode" for details. • Reset Lamp Timer Activate this function only after a new lamp is installed. When you select Reset, a "Reset Successfully" message displays to notify that the lamp time has been reset to "0". • Lamp Information Select to learn the duration (in hours) of lamp usage which is automatically calculated by the built-in timer. There is one 12V trigger that works according to your needs for installation scenarios. Two selections are available: • Off: If this is selected, the projector will not send electronic signal out when it is turned on. • On: The projector will send a low to high electronic signal out when it is turned on, a high to low signal out when it is turned off. 24 Menu Functions