Kenmore 75121 Owners Manual - Page 10
Features, Using, The Air Conditioner - installation instructions
View all Kenmore 75121 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
FEATURES 1 15 6 5 98 1. Cabinet 2. Vertical Air Direction Louvers 3. Horizontal Air Direction Louvers 4. Inlet Grille 5. Air Filter 6. Front Grille 7. Control Board 8. Power Cord 4 32714 11 1210 13 16 FIG. 24 9. Evaporator Coil 10. Condenser 11. Compressor 12. Base pan 13. Brace 14. Upper Guide 15. Curtain 16. Remote Control USING THE AIR CONDITIONER To reduce the risk of fire, electric shock, or injury to persons, read the important SAFETY instructions section before operating this appliance To begin operating the air conditioner after installation, follow these steps: 1. Plug in the air conditioner. (To prevent electrical hazards, do not use an extension cord or an adapter plug.) 2. Set the exhaust vent to the CLOSE position. 3. Set the TEMP Control to the coolest setting. 4. Set the MODE control at the highest COOL level. 5. Adjust the louvers for comfortable air flow. 6. Once the room has cooled, adjust the TEMP and Mode Control to the setting you find most comfortable. NOTE : If the air conditioner is turned off, wait 3 minutes before restarting. This allows pressure inside the compressor to equalize. Failure to wait 3 minutes before restarting may cause inefficient operation. If you move the TEMP Control to a warmer, then immediately back to a cooler setting, the unit will shut off. Wait 3 minutes before restarting. VENT CONTROL The Vent Control allows the air conditioner to either recirculate inside air (CLOSE) or exhaust air te the outside (OPEN). (FIG. 25) • The CLOSE position is used when maximum cooling is desired. It may also be used for air recirculation without cooling when the air conditioner is set in the FAN position. • The OPEN position removes stale air from the room and exhausts it to the outside. Fresh air is drawn into the room through your home's normal air passages. • The OPEN or CLOSE position can be used with any fan selection. -10- PULL OPEN / PUSH CLOSE FIG. 25