Kenwood C-707I User Manual - Page 81
Device connected to the [iPod] terminal, Remote control, Resetting the microcomputer
![]() |
View all Kenwood C-707I manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
Troubleshooting Device connected to the [iPod] terminal Symptoms Solution iPod is not recognized. Cannot control the iPod. Poor response. Connect with a PNC-iP120 iPod connection cable (optional accessory). Connect the PNC-iP120 iPod connection cable securely. Check that the iPod model is compatible for playback by the system. Disconnect the iPod from the system, disconnect all devices from the iPod, and then re-connect it to the system. Check that the iPod model is compatible for playback by the system. iPod response becomes poor when there is a large number of tracks on the iPod. This is particularly true when shuffle is turned on for a large number of tracks, which can cause poor response of the iPod itself. Ref. page 17 17 27 17 27 27 Remote control Symptoms The remote control does not work. Solution Load new batteries. Use the remote control within its effective range. Ref. page 21 21 Resetting the microcomputer Symptoms Solution Microcomputer malfunction (the system does not work, the display is faulty, etc.). Reset Procedure (Main unit only) 1 Turn off the power (press the [K] key to enter Standby mode). 2 While holding down the [H] and [STOPF] keys on the main unit, hold down the main unit's power [K] key until the message "CLEAR ALL" appears on the display. Remember that resetting erases any stored information and restores the system's default settings. English 81
![](/manual_guide/products/kenwood-c707i-user-manual-762d99c/81.png)