Kenwood DDX775BH America - Page 2

Important Notice To ensure proper use, please read through this manual before using this product. It is especially important that you read and observe WARNINGS and CAUTIONS in this manual. Please keep the manual in a safe and accessible place for future reference. WARNINGS To prevent accidents and damages • DO NOT install any unit or wire any cable in a location where; - it may obstruct the steering wheel and gearshift lever operations. - it may obstruct the operation of safety devices such as air bags. - it may obstruct visibility. • DO NOT raise the volume level too much, as this will make driving dangerous by blocking outside sounds, and may cause hearing loss. • DO NOT operate the unit while driving. If you need to operate the unit while driving, be sure to look around carefully. • Stop the car before performing any complicated operations. • The driver must not watch the monitor while driving. CAUTIONS To care for the unit • If you have parked the car for a long time in hot or cold weather, wait until the temperature in the car becomes normal before operating the unit. To care for the monitor • The monitor built into this unit has been produced with high precision, but it may have some ineffective dots. This is inevitable and is not considered defective. • Do not expose the monitor to direct sunlight. • Do not operate the touch panel using a ball-point pen or similar tool with a sharp tip. Touch the keys on the touch panel with your finger directly (if you are wearing a glove, take it off). • When the temperature is very cold or very hot... - Chemical changes occur inside, causing malfunction. - Pictures may not appear clearly or may move slowly. Pictures may not be synchronized with the sound or picture quality may decline in such environments. On the volume setting • Digital devices produce very little noise compared with other sources. Lower the volume before playing these digital sources to avoid damaging the speakers by sudden increase of the output level. For DDX6018BT/DDX5018BT/DDX718WBTL: The marking of products using lasers The label is attached to the chassis/case and says that the component uses laser beams that have been classified as Class 1. It means that the unit is utilizing laser beams that are of a weaker class. There is no danger of hazardous radiation outside the unit. For DDX795/DDX775BH/DDX595/DDX575BT: CAUTION Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. In compliance with Federal Regulations, the following are reproductions of labels on, or inside the product relating to laser product safety. Location : Top plate i ENGLISH