Kenwood DNX6190HD Instruction Manual - Page 46

Return to the Top page Audio Setting Up Controlling Audio NOTE • Each operation in this section can be started from the multi function menu. You can adjust the various settings such as audio balance or subwoofer level. 1 Touch [Menu] on any screen. 2 Touch [Audio]. Audio screen appears. See the following section for each setting. • Setting audio (P.90) • Controlling audio (P.94) • Controlling equalizer (P.95) • Performing zone control (P.97) • Set space enhancer (P.97) • Set listening position (P.98) Setting Audio 1 Touch [Audio SETUP]. • Set up speakers (P.90) • Set up your car type (P.92) • Select DSP (P.93) • Set up elevation (P.93) Speaker Select screen appears. • Set up speakers (P.90) Speaker setup You can select a speaker type and its size to get the best sound effects. When the speaker type and size are set, the speaker crossover network is set automatically. 1 Touch [Speaker Select] in the Audio SETUP screen. Speaker Select screen appears. Audio SETUP screen appears. 2 Touch the speaker you wish to adjust and set each item as follows. See the following section for each setting. 90 Subwoofer Select if you are using a subwoofer. Tweeter You can set the tweeter when you are selecting front speakers. If you are using a tweeter together with the front speakers, set the tweeter to "ON". X'over Displays the speaker crossover setup screen. You can adjust the crossover setup that was set automatically when you selected the speaker type. For details, see Crossover network setup (P.91) 3 Select a speaker size using [2] and [3]. The speaker size is different depending on the speaker type and the unit. Front OEM, 4 inch, 5 inch, 6-1/2 inch, 6-3/4 inch, 4-3/4 inch, 3-1/2 inch, 7 inch, 4x6, 5x7, 6x8, 6x9, 7x10 Rear None, OEM, 4 inch, 5 inch, 6-1/2 inch, 6-3/4 inch, 4-3/4 inch, 3-1/2 inch, 7 inch, 4x6, 5x7, 6x8, 6x9, 7x10 Subwoofer None, 6 1/2 inch, 8 inch, 10 inch, 12 inch, 15 inch over NOTE • Select "None" if you have no speakers. Front Standard, Wide, Middle, Narrow Return to the Top page Audio Setting Up Crossover network setup You can set a crossover frequency of speakers. 1 Touch the speaker to set the crossover in the Speaker Select screen. 2 Touch [X'over]. X'over screen appears. 3 Set each item as follows. Phase* Sets the phase of subwoofer output. The phase is reversed 180 degrees when set to "Reverse". HPF FREQ High Pass Filter adjustment. (When front or rear speaker is selected on Speaker Select screen) LPF FREQ Low Pass Filter adjustment. (When subwoofer is selected on Speaker Select screen) Slope Sets a crossover slope. * T his function is available in the specific situation. Only when "Subwoofer" is set to other than "None" in "Speaker Setup". Only when "Subwoofer" is set to "ON" in "Speaker Setup" and "LPF FREQ" is set to other than "Through". 91