Kenwood DPX794BH Instruction Manual - Page 42
Part list for installation, Basic procedure, Installing the unit in-dash mounting
View all Kenwood DPX794BH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Installation/Connection Part list for installation (Parts supplied for / (A) Mounting sleeve ( ×1 ) / ) (B) Trim plate ( ×1 ) (C) Trim plate (only for Toyota car) ( ×1 ) (D) Extraction key ( ×2 ) (Parts supplied for all models) (E) Round head screw ( ×6 ) ( ) (G) Wiring harness ( ×1 ) (F) Flat head screw ( ×6 ) ( ) Basic procedure 1 Remove the key from the ignition switch, then disconnect the terminal of the car battery. 2 Connect the wires properly. See "Wiring connection" on page 38. 3 Install the unit to your car. See the following "Installing the unit (in-dash mounting)". 4 Connect the terminal of the car battery. 5 Press BSRC to turn on the power. 6 Reset the unit. (Page 4) Installing the unit (in-dash mounting) (For / / ) Do the required wiring. (Page 38) Bend the appropriate tabs to hold the mounting sleeve firmly in place. Dashboard of your car 36 ENGLISH