Kenwood KXF-W6010 User Manual - Page 18

How to record (CT-203/KXF-W4010; Deck B only) CT-2050/203/KXF-W6010/W4010 (En/M) 18 To pause recording temporarily Pause 8PAUSE To resume recording ¶REC/ARM ÷ The 8 indicator lights. To stop recording 1 Stop the tape transport. CT-2050/KXF-W6010 2 7 3 CT-203/KXF-W4010 2 Stop playing the source component. How to provide non-recorded blanks between programs In stop mode Press successively twice. ¶REC/ARM During recording Press once. ¶REC/ARM ÷ After leaving a non-recorded blank of about 4 seconds, the deck enters the record-pause mode. To start recording again from the biginning The following procedure is useful when you want to cancel recording in progress and re-start it. A non-recorded space of about 4 seconds or more should be reserved before the position where recording was started. 1 Rewind during recording. During recording in the 3 direction: 1 ¡ ÷ When the ¡ (or 1) key is pressed during recording, recording is aborted and tape is rewound as shown below if there is a non-recorded space of more than 4 seconds before the recording start position. Tape stops after 2 sec. of transport. Recorded tune Re-recording Tune to be re-recorded. During recording in the 2 direction: 1 ¡ 2 Press the REC/ARM (¶) key twice. CT-2050/KXF-W6010 ¶REC/ARM CT-203/KXF-W4010 3 Replay the tune you wish to record. 4 Press the REC/ARM (¶) key once. ¶REC/ARM Blank of 4 sec. or more. ÷ If there is no recorded tune before, the tape will be rewound then stopped. ÷ When re-recording from the beginning of tape, feed the leader tape (the first portion of tape that cannot be recorded) before starting rerecording. ÷ A non-recorded space of about 4 seconds is reserved on tape, then the tape transport stops. ÷ Recording starts.