Kenwood TS-870S User Manual - Page 32

5 MENU SETUP Menu No. 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 Menu Item VOX.GAIN TX.WIDTH TX.SHIFT TX EQ. AUTO.RET TUN.WIDE AUT.MODE BEEP BP. MODE WARN. BP BP LV REPEAT REP.TIME F.STEP BC. STEP CH. STEP STEP.ADJ PF.KEY.UL PF.KEY.UR PF.KEY.LR Function Selections Default Page Ref. VOX gain 0 ~ 7 4 45 • 0 (minimum gain) → 7 (maximum gain) TX bandwidth for SSB and AM modes TX bandshift for SSB and AM modes 1800/ 2000/ 2300/ 2300 Hz 47 2600/ 3000 Hz 0/ 100/ 200/ 300/ 300 Hz 47 400/ 500 Hz TX equalizer for SSB mode • H: High boost • C: Comb filter • B: Bass boost H/ C/ B H 47 Transceiver status after tuning with the antenna tuner • OFF: Transmit status maintained • ON: Receive status restored Note: If OFF is selected, the transmit status can be aborted by pressing [AT TUNE]. OFF may be selected if using a linear amplifier. OFF/ON ON _ Allowable SWR range for Antenna Tuner • Tuning stops if: OFF: SWR ≤ 1.2:1 (approx.) ON: SWR ≤ 1.6:1 (approx.) Automatic Mode OFF/ON OFF 49 OFF/ON OFF 48 Button confirmation/ Alarm tone enable OFF/ON ON 64 • OFF: No Confirmation or Alarm tones • ON: Confirmation and Alarm tones audible Morse code enable for the operating mode OFF/ON ON 65 • OFF: Single beep • ON: Morse code Error message enable for alarm notification OFF/ON ON 65 • OFF: Triple beep • ON: Morse error message Beep output level 0 ~ 9 4 64 • 0 (minimum level) → 9 (maximum level) Playback repeat OFF/ON OFF 67 Interval between repeated playbacks 1/ 2/ 3/ 4/ 5/ 10/ 15/ 5 sec 68 20/ 25/ 30/ 35/ 40/ 45/ 50/ 55/ 60 sec Frequency change for one revolution of the 5/ 10 kHz 10 kHz 21 Tuning control in SSB, CW, FSK (FINE : OFF) 9 kHz step enable for the M.CH/VFO.CH control in the AM Broadcast band for AM mode • OFF: 10 kHz steps • ON: 9 kHz steps Frequency step size outside the AM broadcast band for the M.CH/VFO.CH control Alters the function of the M.CH/VFO.CH control if you are operating in VFO mode. • OFF: M.CH/VFO.CH steps the VFO frequency from the current frequency without rounding. • ON: M.CH/VFO.CH steps the VFO frequency but first rounds off the current frequency. Programmable Function button (upper left) OFF/ON 1/ 5/ 10 kHz OFF/ON OFF, 00 ~ 73 See page 21 reference 10 kHz 21 ON 21 69 63 (ENTER) Programmable Function button (upper right) OFF, 00 ~ 73 70 63 (TF-SET) Programmable Function button (lower right) OFF, 00 ~ 73 71 (1MHz) 63 26