Kenwood TS-870S User Manual - Page 92

● APPENDICES Command Function FB Sets or reads VFO B frequency. FD Reads RX filter dot display. FR Sets RX (VFO A/B, memory channel). FS Fine function (OFF/ON) FT Sets TX (VFO A/B, memory channel). FW Sets or reads filter bandwidth. For SSB and AM, sets or reads the high-pass filter cut-off frequency. ɹɹɹ
GT Sets or reads AGC time constant. ID Reads model number of the transceiver. IF Reads status of the transceiver. IS Sets or reads IF shift. For SSB and AM, sets or reads the low-pass filter cut-off frequency. KS Sets or reads keying speed while using the KY command. KY Converts input characters into Morse code. LK Sets or reads Lock (OFF/ON). LM DRS recording MC Sets or reads memory channels. MD Sets or reads modes. MG Sets or reads MIC gain. ML Sets or reads transmit monitor level. MN Sets or reads Transmit Monitor (OFF/ON). MR Reads memory. MW Writes into memory. MX Sets or reads AIP (OFF/ON). NB Sets or reads Noise Blanker (OFF/ON). NL Sets or reads Noise Blanker level. NR Sets or reads Noise Reduction (OFF/ON). NT Sets or reads Notch Filter. PB DRS playback. PC Sets or reads transmit power. PL Sets or reads Speech Processor level. PR Sets or reads Speech Processor (OFF/ON). PS Sets or reads power (OFF/ON). RA Sets or reads RF ATT (attenuator). RC Clears RIT frequency. RD Lowers RIT frequency. RG Sets or reads RF gain. Command Function RM Selects a meter function or reads meter values. RT Sets or reads RIT (OFF/ON). RU Raises RIT frequency. RX Selects receive mode. SC Sets or reads Scan (OFF/ON). SD Sets or reads Semi Break-in delay time. SM S-meter and TX RF meter readings SQ Sets or reads squelch level. SR Resets the transceiver. TX Selects transmit mode. UP MIC UP function VD Sets or reads VOX delay time. VR Triggers the Voice Synthesizer for message output. VX Sets VOX (OFF/ON). XT Sets or reads XIT (OFF/ON). ERROR MESSAGES In addition to the Answer Command, the transceiver can send the following error messages: Error Message ?; E; O; Reason for Error • Command syntax was incorrect. • Command was not executed due to the current status of the transceiver (even though the command syntax was correct). Note: Occasionally this message may not appear due to microprocessor transients in the transceiver. A communication error occurred such as an overrun or framing error during a serial data transmission. Receive data was sent but processing was not completed. COMMAND USE PRECAUTIONS 1 Do not use the control characters 00 to 1Fh since they are either ignored or cause a "?" answer. 2 Program execution may be delayed while turning the Tuning control rapidly. 3 Receive data is not processed if the frequency is entered from the keypad. 86