Kyocera KM-C830D Printing System (P) Operation Guide (Setup Edition) - Page 14
When an error message appears
View all Kyocera KM-C830D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
3. Troubleshooting 3-2 When an error message appears... If an error message appears on the operation panel, first check the following tables for cause of the trouble and then perform the corresponding procedure. For more detailed information, refer to the Operation Guide for your copier as well as the Operation Guide for any optional equipment that is installed in your machine. If "Error in printer mode" is displayed, press the Printer key. A more specific message about the error will be displayed. Display message Add paper in drawer. XX size (XXX) ADD PAPER IN DRAWER. XX SIZE (XXX) Procedure The size or type of paper selected for printing does not match the size or type of paper in the drawer. Replace the paper in the drawer with that of the correct size and type. 1. If you want to switch to and print from a different drawer, press the Paper Select key until the desired drawer is selected and then press the Enter key. 2. Otherwise, use the M and N keys to move the arrow e until it points to the desired command and then press the Enter key. GO: Force-prints onto the current size or type of paper. CANCEL: Cancels the printing operation completely. Bypass Type: Changes the type of paper to be used in the Multi-Bypass. Use the M and N keys to move the arrow e until it points to the desired paper type and then press the Enter key. RESET: Resets the Printer Board. (Only printer functions will be reset.) Use alternative? Press GO USE ALTERNATIVE? PRESS GO Set paper Press GO SET PAPER PRESS GO Displayed when the selected drawer has been changed. Use the M and N keys to select the "On" command and then press the Enter key. This message appear in the mode which allows you to select to have multiple copies made but only one page printed at a time. After each sheet is printed, use the M and N keys to select the "On" command and then press the Enter key. Place paper in drawer. PLACE PAPER IN PAPER DRAWER. The drawer has run out of paper. Add paper. Add staples. ADD STAPLES. Call service. CALL SERVICE. Department code mismatch DEPARTMENT CODE MISMATCH Exceeded print quantity limit. EXCEEDED PRE-REGISTERED PRINTING QUANTITY. The finisher (option) has run out of staples. Refer to the Operation Guide for the finisher and replenish the staples. Trouble has occurred within the printer. Contact your service representative or an authorized service center. The department code you entered does not match the registered one. Check the department code that is registered in the printer driver. The amount of printing accomplished has exceeded the acceptable capacity as set under copy management. In order to print further, change the copy management setting in the printer. 9