Kyocera TASKalfa 4820w TASKalfa 4820w Operation Guide - Page 21
Kyocera TASKalfa 4820w Manual
View all Kyocera TASKalfa 4820w manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
1. 7. 3 Humidity(%) Treatment against environmental condition Possible problem "Void of image", "crease of paper" and other problems occurs when you print with plain paper and tracing paper. "Void of image" occurs when you print with tracing paper. Necessary treatment 1. Install the humidifier in the room, and humidify the room air. 2. Remove the paper from the machine right after the completion of print, and keep it in a polyethylene bag. If you will not make print soon, remove the tracing paper from the machine and keep it in a polyethylene bag. Remove the paper from the machine after everyday use, and keep it in a polyethylene bag. If you will not make print soon, remove the tracing paper from the machine and keep it in a polyethylene bag. 1. Turn on the Dehumidify Heater. (if installed) 2. Remove the paper from the machine right after the completion of print, and keep it in a polyethylene bag. Take a necessary treatment according to the environmental condition as shown below. Low 40% 70% "Void of image" occurs when you print with plain paper and tracing paper. "Void of image", "crease of paper" and other problems occurs when you print with plain paper and tracing paper. High NOTE (1) This machine is equipped with the Dehumidify Heater (optional). Using it in high humidity environment (75% or higher) is recommended. Refer to [2.9 Dehumidifying Roll Paper]. (2) "Void of image" and "crease of paper" will occur in case of extremely high or low humidity. Normal Print Crease of paper If the media is humidified; Normal Print Loss of image If the media is humidified; 1-16 Chapter 1 Before Use