LG 26LD320H Setup Guide - Page 23
Cloning Overview
![]() |
View all LG 26LD320H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Cloning Overview IMPORTANT CLONING INFORMATION There are three different procedures for cloning a Master TV Setup, each with its own advantages and limitations (see also "Cloning Methods" on page 11): • Using a USB memory device • Using a TLL-1100A clone programmer • Using a LT2002 clone programmer Each cloning method is described in further detail on the pages that follow. As you perform cloning procedures, be sure to complete each task as indicated. If a procedure or step is omitted or not performed completely, cloning may not work. At each step, pay attention to ensure the TV screen shows the proper message when cloning. If the message indicated does not appear, there is a problem with that step, and cloning may not be successful. Caution: Copying a blank or incorrect memory into a TV from a clone programmer will cause the TV to operate erratically or become inoperable. Caution: Do not connect a clone programmer to a PPV card installed in the Master or Target TVs. Also, if the TV is in LodgeNet PPV Mode (check with the site administrator if you are not certain), do not connect a clone programmer to the GAME CONTROL/MPI port. Either of these actions will damage the clone programmer and, if applicable, the PPV card. Before you begin cloning: • Complete the Master TV Setup procedure (see pages 11 to 14). • All equipment should be connected to power and turned ON. • Both the Master and Target TVs must be in Pass-through Mode. • Learning and Teaching is only possible between identical model TVs. • If using a USB memory device, ensure the USB device has been formatted with FAT format. • For both Master and Target TVs-If using a clone programmer, ensure the TV is tuned to either an Aux input or an analog (not a digital) channel. • LT2002 only-Make sure the batteries in the clone programmer are fresh. If batteries are removed, the clone programmer clock time (if set) will be lost (see page 29 for information on the clone programmer clock). Caution: Do not unplug the TV power cord or remove/disconnect the USB memory device/ clone programmer while Learning or Teaching, as doing so may cause the TV to malfunction or harm the USB device/clone programmer, respectively. 206-4186 23
![](/manual_guide/products/lg-26ld320h-setup-guide-930103c/23.png)