LG 26LD320H Setup Guide - Page 25

USB Cloning Procedure (Cont.) Learning / Teaching a Master TV Setup using a USB Memory Device (Cont.) Teach Master TV Setup to Target TV 1. Ensure the Target TV is in Pass-through Mode, and then use the Installer Remote to enter the Target TV Installer Menu: Press MENU repeatedly until the on-screen display of the TV setup menus no longer toggles, and then press 9-8-7-6 + ENTER. 2. Set Installer Menu item 117 FACT DEFAULT to 001, and press ENTER. When the value changes back to 0, press ENTER again to exit the Installer Menu. 3. Tune/set the TV to an analog or digital channel or Aux input, (ideally the same source tuned for 2-5-5 + MENU Mode during the Master TV Setup procedure). 4. Plug the USB memory device with the .tll file into the Target TV USB IN port. 5. Press MENU on the Installer Remote to display the TV setup menus. Use the arrow navigation keys to select/highlight the Option menu icon, and then press the number "7" key a total of seven times to display the USB Download Menu. 6. Use the Up/Down arrow keys to select Teach To TV (TLL), and then press ENTER. 7. Use the Up/Down arrow keys to select the Master TV Setup you want to install, and then press ENTER. Note: Filenames identify the TV and the TLL version (see example at right). Teaching status will be shown on the progress bar. When the Teaching process is complete, the USB Download menu will reappear on screen. 8. When Teaching is done, remove the USB memory device from the Target TV, turn OFF the TV, and unplug the TV power cord for 15 seconds. 9. Reconnect the TV power cord, and turn ON the TV. The Master TV Setup should be resident on the Target TV. USB Download Menu Upgrade TV Software Upgrade PTC Software Teach To TV (TLL) Teach To TV (FMA) Return Enter Teach To TV (TLL) xxLD340H-UA00001.TLL Return Enter ! Teach To TV UPDATING... 50% Do not remove the USB from the port! Do not unplug! 206-4186 25