LG DU-37LZ30 Owners Manual - Page 14

TV Speaker - instructions

Page 14 highlights

Installation HDSTB Setup - This TV can receive Digital Over-the-air/Cable signals without an external digital set-top box. However, if you do receive Digital signals from a digital set-top box or other digital external device, refer to the figure as shown below. - This TV supports HDCP (High-bandwidth Digital Contents Protection) protocol for DTV (480p,720p,1080i) mode. UPGRADE PORT DVI COMPONENT1 PC/DVI OUTPUT INPUT INPUT AUDIO INPUT DIGITAL AUDIO (OPTICAL) RGB INPUT (PC/DTV INPUT) DVI COMPONENT1 PC/DVI OUTPUT INPUT INPUT AUDIO INPUT DIGITAL AUDIO (OPTICAL) RGB INPUT (PC/DTV INPUT) COMPONENT 2 COMPONENT 1 R L DVD /DTV INPUT MONITOR OUTPUT A/V INPUT1 (MONO) R AUDIO L VIDEO AUDIO INPUT VIDEO INPUT S-VIDEO DVI COMPONENT1 PC/DVI OUTPUT INPUT INPUT AUDIO INPUT DIGITAL AUDIO (OPTICAL) RGB INPUT (PC/DTV INPUT) COMPONENT 2 COMPONENT 1 R L DVD /DTV INPUT MONITOR OUTPUT A/V INPUT1 (MONO) R AUDIO L VIDEO AUDIO INPUT VIDEO INPUT S-VIDEO Antenna1 DVI INPUT (PC/DTV INPUT) Antenna 2 or or (R) AUDIO (L) RGB-DTV OUTPUT or DIGITAL AUDIO OPTICAL (R) AUDIO (L) B R Digital Set-top Box How to connect Use the TV's COMPONENT (Y, PB, PR) INPUT, RGB or DVI jack for video connections, depending on your set-top box connector. Then, make the corresponding audio connections. How to use 1. Turn on the digital set-top box. (Refer to the owner's manual for the digital set-top box.) 2. Use TV/VIDEO or COMP/RGB/DVI on the remote control to select Component 1, Component 2, RGB-DTV, or DVI-DTV source. or DIGITAL AUDIO OPTICAL (R) AUDIO (L) DVI-DTV OUTPUT Signal 480i 480p 720p 1080i Component 1/2 RGB-DTV,DVI-DTV Yes No Yes Yes Yes Yes Yes Yes Digital Audio Output Send the TV's audio to external audio equipment (stereo system) via the Digital Audio Output Optical port. How to connect 1. Connect one end of an optical cable to the TV Digital Audio Optical Output port. 2. Connect the other end of the optical cable to the digital audio optical input on the audio equipment. 3. Set the " TV Speaker option - Off" in the AUDIO menu. Refer to page 23. See the external audio equipment instruction manual for operation. Caution: Do not look into the optical output port. Looking at the laser beam may damage your vision. 14 REMOTE CONTROL UPGRADE PORT DVI COMPONENT1 PC/DVI OUTPUT INPUT INPUT AUDIO INPUT DIGITAL AUDIO (OPTICAL)

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48

14
Installation
Send the TV’s audio to external audio equipment (stereo system) via
the Digital Audio Output Optical port.
How to connect
1. Connect one end of an optical cable to the TV Digital Audio Optical
Output port.
2. Connect the other end of the optical cable to the digital audio optical
input on the audio equipment.
3. Set the “
TV Speaker
option -
Off
in the AUDIO menu. Refer to
page 23.
See the external audio equipment instruction manual for operation.
Caution
: Do not look into the optical output port.
Looking at the laser beam may damage
your vision.
Digital
Digital
Audio Output
Audio Output
-
This TV can receive Digital Over-the-air/Cable signals without an external digital set-top box. However, if you do receive Digital
signals from a digital set-top box or other digital external device, refer to the figure as shown below.
-
This TV supports HDCP (High-bandwidth Digital Contents Protection) protocol for DTV (480p,720p,1080i) mode.
How to connect
Use the TV’s COMPONENT (Y, P
B
, P
R
) INPUT, RGB or DVI jack for
video connections, depending on your set-top box connector. Then,
make the corresponding audio connections.
How to use
1. Turn on the digital set-top box. (Refer to the owner’s manual for the
digital set-top box.)
2. Use
TV/VIDEO
or
COMP/RGB/DVI
on the remote control to select
Component 1
,
Component 2
,
RGB-DTV
, or
DVI-DTV
source.
HDSTB Setup
HDSTB Setup
UPGRADE
PORT
RGB INPUT
(PC/DTV INPUT)
DIGITAL AUDIO
(OPTICAL)
DVI
INPUT
PC/DVI
AUDIO INPUT
COMPONENT1
INPUT
OUTPUT
S-VIDEO
RGB INPUT
(PC/DTV INPUT)
AUDIO INPUT
AUDIO
VIDEO
VIDEO INPUT
DIGITAL AUDIO
(OPTICAL)
COMPONENT 2
MONITOR
OUTPUT
A/V
INPUT1
DVD
/DTV
INPUT
COMPONENT 1
DVI
INPUT
PC/DVI
AUDIO INPUT
R
L
R
L
COMPONENT1
INPUT
OUTPUT
B
R
(R) AUDIO (L)
(R) AUDIO (L)
RGB-DTV OUTPUT
DIGITAL AUDIO
OPTICAL
Antenna1
Antenna 2
S-VIDEO
RGB INPUT
(PC/DTV INPUT)
DVI INPUT
(PC/DTV INPUT)
AUDIO INPUT
AUDIO
VIDEO
VIDEO INPUT
DIGITAL AUDIO
(OPTICAL)
COMPONENT 2
MONITOR
OUTPUT
A/V
INPUT1
DVD
/DTV
INPUT
COMPONENT 1
DVI
INPUT
PC/DVI
AUDIO INPUT
R
L
R
L
COMPONENT1
INPUT
OUTPUT
(R) AUDIO (L)
DVI-DTV OUTPUT
DIGITAL AUDIO
OPTICAL
Digital Set-top Box
or
or
or
or
REMOTE
CONTROL
UPGRADE
PORT
DIGITAL AUDIO
(OPTICAL)
DVI
INPUT
PC/DVI
AUDIO INPUT
COMPONENT1
INPUT
OUTPUT
Signal
480i
480p
720p
1080i
Component 1/2
Yes
Yes
Yes
Yes
RGB-DTV,DVI-DTV
No
Yes
Yes
Yes