Lantronix EDS32PR EDS - Command Reference - Page 197
lpd 4 config-lpd:4 level commands, Redirects serial output back to the line.
View all Lantronix EDS32PR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 197 highlights
show statistics soj disable soj enable soj text binary soj text set terminal terminal network test print tunnel write lpd 4 (config-lpd:4) level commands banner disable banner enable binary disable binary enable capture disable capture enable clrscrn convert newline disable convert newline enable eoj disable eoj enable eoj text binary eoj text set EDS Command Reference 5: Commands and Levels CLI session. Displays statistics and status information for this lpd line. Disables sending the start-of-job string after each print job. Enables sending the start-of-job string after each print job. Sets the start-of-job text allowing for binary characters. = string in binary format that will be sent to the printer at the beginning of each print job. Within [] use binary decimal up to 255 or hex up to 0xFF. Sets the start-of-job text. = ascii string that will be sent to the printer at the beginning of each print job. Enters the configure-terminal level. = number of the terminal line (serial port) to be configured. Enters the configure-terminal level for the network. Prints lines of text directly to the lpd line. = number of lines to print. Enters the tunnel level. = number of the tunnel line (serial port) to be configured. Stores the current configuration in permanent memory. Disables printing banner for all print jobs. Only print the banner when a job requests it. Enables printing banner for all print jobs. Treats print job as ascii text. Filters out all non-ascii characters and certain control characters. Treats print job as binary. Sends data byte-for-byte to the printer. Redirects serial output back to the line. Redirects serial output from the line to this CLI session. Clears the screen. Disables converting single new line and carriage return characters to DOS-style line endings. Enables converting single new line and carriage return characters to DOS-style line endings. If characters are already in DOS line-ending order, they are not converted. Disables sending the end-of-job string after each print job. Enables sending the end-of-job string after each print job. Sets the end-of-job text allowing for binary characters. = string in binary format that will be sent to the printer at the end of each print job. Within [] use binary decimal up to 255 or hex up to 0xFF. Sets the end-of-job text. = ascii string that will be sent to the printer at the 197