Lantronix EPS2-100 EPS2-100 - Install Guide - Page 21
Change, IPaddress, etc/hosts, con d in the unix file - password
View all Lantronix EPS2-100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
TCP/IP Configuration administrator to Telnet into the EPS. Once logged in, the administrator can enter the Change IPaddress command to make the address permanent. % telnet 192.0.1.228 Trying 192.0.1.228 Lantronix Version n.n/n (yymmdd) Type Help at the 'Local_>' prompt for assistance. Enter Username> gopher Local> SET PRIVILEGED Password> system (not echoed) Local>> DEFINE IPADDRESS 192.0.1.228 Any host wishing to access the EPS will have to be told the EPS's IP address. This is typically configured in the unix file /etc/hosts or via a nameserver. Refer to the host's documentation for additional information. 4 - 5
TCP/IP Configuration
4 - 5
administrator to Telnet into the EPS. Once logged in, the administrator can enter the
Change
IPaddress
command to make the address permanent.
Any host wishing to access the EPS will have to be told the EPS’s IP address. This is typically
configured in the unix file
/etc/hosts
or via a nameserver. Refer to the host’s documentation for
additional information.
% telnet 192.0.1.228
Trying 192.0.1.228
Lantronix Version n.n/n (yymmdd)
Type Help at the ‘Local_>’ prompt for assistance.
Enter Username> gopher
Local> SET PRIVILEGED
Password> system (not echoed)
Local>> DEFINE IPADDRESS 192.0.1.228