Lantronix SLC 16 Lantronix SLC - User Guide - Page 55

6: Basic Parameters Figure 6-4 Adding Network IP Filter Rulesets 2. Enter the Ruleset Name. The Ruleset Name identifies a filter. The name can be letters, numbers, and hyphens only but cannot start with a hyphen. For example, FILTER-2. 3. Enter following fields. Rule Parameters IP Address Subnet Mask Protocol Port Range Specify a single IP address to act as a filter. Example: 172.19.220.64 - this specific IP address only Specify a subnet mask to act as a filter. Example: 255.255.0.0 Select from the drop-down list the type of protocol through which the filter will operate. The default setting is All. Enter a range of destination TCP or UDP port numbers to be tested. An entry is required for TCP, TCP New, TCP Established, and UDP, and is not allowed for other protocols. Separate multiple ports with commas. Separate ranges of ports by colons. Examples: 22 - filter on port 22 only 23,64,80 - filter on ports 23, 64 and 80 23:64,80,143:150 - filter on ports 23 through 64, port 80 and ports 143 through 150 SLC™ Console Manager User Guide 55