Lenovo ThinkCentre E51 Hardware Maintenance Manual - Page 68

Diagnostic Error Code 011-197-XXX Serial port test warning 011-198-XXX Serial port test aborted 011-199-XXX Serial port test failed, cause unknown 011-2XX-XXX Serial port signal failure 014-000-XXX Parallel port Interface Test Passed 014-001-XXX Parallel port Presence 014-002-XXX 014-003-XXX Parallel port Timeout/Parity error 014-013-XXX 014-014-XXX Parallel port Control Signal/Loopback test failure 014-015-XXX Parallel port External Loopback failure 014-027-XXX Parallel port Configuration/Setup error 014-03X-XXX 014-04X-XXX Parallel port failure 014-195-XXX Parallel port Test aborted by user FRU/Action 1. Make sure the component that is called out is connected and/or enabled. See Chapter 6, "Using the Setup Utility," on page 49 2. Re-run test 3. Replace the component that is called out in warning statement 4. Replace the component under test 1. If a component is called out, make sure it is connected and/or enabled. See Chapter 6, "Using the Setup Utility," on page 49 2. Flash the system and re-test. See "Flash update procedures" on page 337 3. Go to "Undetermined problems" on page 80 1. Go to "Undetermined problems" on page 80 2. Flash the system and re-test. See "Flash update procedures" on page 337 3. Replace component under function test 1. External serial device 2. System board No action 1. Remove external parallel device, if present 2. Run setup, enable port 3. System board System board System board 1. Wrap plug 2. System board 1. Run Setup, enable port 2. Flash the system. See "Flash update procedures" on page 337 3. System board System board Information only Re-start the test, if necessary 62 Hardware Maintenance Manual