Lenovo ThinkCentre M51 Hardware Maintenance Manual - Page 76
action
View all Lenovo ThinkCentre M51 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
Diagnostic Error Code 015-034-XXX USB port buffer allocation failure 015-035-XXX USB port Reset condition detected 015-036-XXX USB port Register error 015-040-XXX USB port IRQ failure 015-195-XXX USB port Test aborted by user 015-196-XXX USB port test halt, error threshold exceeded 015-197-XXX USB port test warning 015-198-XXX USB port test aborted 015-199-XXX USB port test failed, cause unknown 018-000-XXX PCI Card Test Passed 018-0XX-XXX PCI Card Failure 018-195-XXX PCI Card Test aborted by user FRU/Action 1. Reboot the system 2. Flash the system and re-test. See "Flash update procedures" on page 338 3. Run memory test 4. System board 1. Remove USB device(s) and re-test 2. System board System board 1. Run setup and check for conflicts 2. Flash the system. See "Flash update procedures" on page 338 3. System board Information only Re-start the test, if necessary 1. Press F3 to review the log file 2. Re-start the test to reset the log file 1. Make sure the component that is called out is connected and/or enabled. See Chapter 6, "Using the Setup Utility," on page 55 2. Re-run test 3. Replace the component that is called out in warning statement 4. Replace the component under test 1. If a component is called out, make sure it is connected and/or enabled. See Chapter 6, "Using the Setup Utility," on page 55 2. Flash the system and re-test. See "Flash update procedures" on page 338 3. Go to "Undetermined problems" on page 90 1. Go to "Undetermined problems" on page 90 2. Flash the system and re-test. See "Flash update procedures" on page 338 3. Replace component under function test No action 1. Riser card, if installed 2. System board 1. PCI card 2. Information only Re-start the test, if necessary 70 Hardware Maintenance Manual