Lenovo ThinkPad X41 (Greek) Service and troubleshooting guide for ThinkPad X41 - Page 37
Solving, computer, problems
View all Lenovo ThinkPad X41 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Solving computer problems Message Solution 0177: Bad SVP data, stop POST task. Checksum of the supervisor password in the EEPROM is not correct. Checksum of the supervisor password in the EEPROM is not correct. The system board should be replaced. Have the computer serviced. 0182: Bad CRC2. Enter BIOS Setup and load Setup defaults. Checksum of the CRC2 setting in the EEPROM is not correct. Press F1 to go to BIOS Setup Utility. Press F9 and then Enter to load the default setting. Press F10 and then Enter to restart the system. 0185: Bad startup sequence settings. Enter BIOS Setup and load Setup defaults. Checksum of the startup sequence setting in the EEPROM is not correct. Press F1 to go to BIOS Setup Utility. Press F9 and then Enter to load the default setting. Press F10 and then Enter to restart the system. 0187: EAIA data access The access to EEPROM is failed. Have the computer serviced. error 0188: Invalid RFID The EEPROM checksum is not correct (block # 0 and 1, or block # 6). The serialization information system board should be replaced, and the box serial number needs to be area . reinstalled. Have the computer serviced. 0189: Invalid RFID configuration information area The EEPROM checksum is not correct (block # 4 and 5). The system board should be replaced, and the UUID needs to be reinstalled. Have the computer serviced. 0190: Critical low-battery The computer turned off because the battery is low. Connect the ac adapter error to the computer and charge the battery, or replace the battery with a fully charged one. 0191: System Security Invalid remote change requested. The system configuration change has failed. Confirm the operation and try again.To clear the error, enter the BIOS Setup Utility, press F9 to set values to default then press F10 to save changes. 0192: System Security Embedded Security hardware tamper detected. The Security Chip has been replaced with a different one. Have the computer serviced. 0199: System Security Security password retry count exceeded. This message is displayed if you enter a wrong supervisor password more than three times. Confirm the supervisor password and try again. To clear the error, enter the BIOS Setup Utility. 01C8: More than one modem devices are found. Remove one of them. Press to continue. Remove either a Modem Mini-PCI Card or a Modem Daughter Card. Otherwise, press Esc to ignore the warning message. If it does not solve this problem, have the computer serviced. 01C9: More than one Ethernet devices are found. Remove one of them. Press to continue. Your ThinkPad computer has a built-in Ethernet feature, and you cannot add another such feature by installing an Ethernet device. If this error message is displayed, remove the Ethernet device that you installed. Otherwise press Esc to ignore the warning message. If this does not solve the problem, have the computer serviced. Chapter 2. Solving computer problems 13