Lexmark 2050 Color Jetprinter Service Manual - Page 19
Diagnostic Information 2-9, Pin 2 to Pin 3 - driver
View all Lexmark 2050 Color Jetprinter manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
FRU Action 2 Paper Feed Motor A noisy or chattering motor or a motor that fails to turn, can be caused by: • An open or short in the motor • An open or short in the motor driver on the system board • A bind in the paper feed mechanism 3 Gears 4 Feed Arm Assembly With the paper feed motor cable disconnected from the system board, check for 100 ohms ±20 ohms) between the following pins on the motor. Pin 1 to Pin 3 Pin 2 to Pin 3 Pin 3 to Pin 4 Pin 3 to Pin 5 If the reading is incorrect, replace the motor. Check for motor pins shorted to the motor housing. If you find a shorted pin, replace the motor. If the failure remains, replace the system board. Although the paper feeds in a forward direction only, the paper feed motor turns in two directions. If the paper feed motor turns in one direction only, replace the system board. Binds in the paper feed motor or gear train can cause intermittent false paper jam errors. Remove the paper feed motor and check the shaft for binds. Also check for loose or worn motor gear. Check for binds in the gear train and paper feed mechanism by rotating the large feed roll by hand. If you notice a bind, isolate it by removing one of the small idler gears on the inside of the left side frame. Replace any worn or binding gears or rollers. At the beginning of the paper feed operation, the paper feed motor reverses momentarily to allow the feed arm pawl to drop off the home position notch in the left side frame. If the pawl fails to drop off the notch, check the feed arm assembly for binds, and worn or broken parts. Diagnostic Information 2-9