Lexmark 7000 Color Jetprinter Service Manual - Page 31

Initialize Error Log, Press the Power Button. When the Power Light begins to flash

Get Lexmark 7000 Color Jetprinter PDF manuals and user guides View all Lexmark 7000 Color Jetprinter manuals
Add to My Manuals
Save this manual to your list of manuals

Page 31 highlights

4092-001 Initialize Error Log This test lets you track new errors. Use this procedure to reset the error log to zero. The error log is especially helpful in diagnosing intermittent or difficult problems. To run the test: 1. Turn the printer off and place a two pin jumper on connector J6 as shown below. (Pins 3 & 4). 2. Place a sheet of paper in the manual feed far enough to activate the EOF (End of Forms) sensor. 3. Press the Power Button. When the Power Light begins to flash, the Error Log clear is complete. (This may take several seconds). To stop the test, turn power off or unplug the printer. Diagnostic Aids 3-3

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
Diagnostic Aids 3-3
4092-001
Initialize Error Log
This test lets you track new errors.
Use this procedure to reset the error log to zero. The error log is
especially helpful in diagnosing intermittent or difficult problems.
To run the test:
1.
Turn the printer off and place a two pin jumper on connector J6
as shown below. (Pins 3 & 4).
2.
Place a sheet of paper in the manual feed far enough to activate
the EOF (End of Forms) sensor.
3.
Press the Power Button. When the Power Light begins to flash,
the Error Log clear is complete. (This may take several
seconds). To stop the test, turn power off or unplug the printer.