Lexmark X644E IPDS Printer and Host Setup Guide - Page 60

IPDS Printer and Host Setup Guide Printer Messages and Problems Network/Ports menu. Problem 11: Not enough memory for IPDS I get the message Not enough memory for IPDS. Solution to Problem 11 If less than 64 MB printer memory is installed, the IPDS Menu settings can be accessed and configured, but IPDS jobs can not be printed from the host (jobs may be printed using other emulations). To activate IPDS printing, make sure that there is at least 64 MB printer memory installed. Problem 12: Recycle Power After I change a setting, the control panel displays not only Submitting Selection , but also Recycle Power. Solution to Problem 12 An established host session was idle when you changed settings. Power the printer OFF then ON. This causes the host to request the new printer settings and make them active. Alternatively, end the current IPDS session at the host and start a new one. Problem 13: Resources Lost The message Resources Lost appears on the display before an IPDS job prints. Solution to Problem 13 IPDS resources were deleted by the printer. A. Try to determine what is causing the resources to be deleted. For more information, refer to the section on IPDS Timeout in the IPDS Emulation User's Guide. B. Non-IPDS jobs may cause IPDS resources to be deleted. Add additional memory. Requirements vary greatly according to type of printing and types of resources being used. For information on the minimum recommended installed memory for various printing requirements on each supported printer, refer to the appendix on memory requirements and recommendations in the IPDS Emulation User's Guide. Problem 14: 1565 EMUL ERROR LOAD EMUL OPTION 1565 EMUL ERROR LOAD EMUL OPTION appears on the display after updating the printer code. Solution to Problem 14 The IPDS emulation version contained in the Card will not function with the printer code. Download the correct IPDS emulation version. See the section on support (page 5) for firmware update information. 60