Lexmark X644E IPDS Printer and Host Setup Guide - Page 8

IPDS Printer and Host Setup Guide AS/400 and iSeries LAN Printing Using the Printer Standard Network Port or MarkNet Internal Print Server Example PSFCFG with parameters to change shown in bold. Cut sheet emulation mode CSEMODE Use DBCS simulation fonts MAPIGCFNT Replace REPLACE Authority AUT *NONE *NO *YES *LIBCRTAUT Note 1: IPDS pass through may be set to *YES. This may increase job performance. Selecting *YES may change the fonts downloaded from the host and change paper jam recovery action between the host and printer. Note 2: Refer to "Printer and Host Timeout Values" [page 50] for information on selecting the Release Timer value. Note 3: Use outline fonts controls the type of fonts downloaded to the printer. When set to *YES, outline fonts are downloaded to the printer. When set to *NO, raster fonts are downloaded to the printer. When the outline or raster fonts are marked eligible for capture on the host, the host will send fonts which can be captured at the printer. Note 4: Capture host fonts at printer must be set to *YES and fonts must be marked eligible to be captured before the host will send fonts which can be captured to the printer. Refer to the IPDS Emulation User's Guide for additional information on capturing fonts. Step 3 Create a Printer Device Description Note: Examples showing parameters displayed on an AS/400 may be different than the parameters displayed on your system. Examples are shown with V5R2 parameters. Create a printer device description for your printer using CRTDEVPRT. Below is an example of a device description. The parameters in bold are the parameters which must be changed for printing IPDS jobs. Example CRTDEVPRT with parameters to change shown in bold. Device description DEVD > IPDSPRT (Note: IPDSPRT is a user defined name.) Device class DEVCLS > *LAN Device type TYPE > *IPDS Device model MODEL >0 LAN attachment LANATTACH > *IP Switched line list SWTLINLST LAN remote adapter address ADPTADR Adapter type ADPTTYPE *INTERNAL Adapter connection type ADPTCNNTYP *PARALLEL Emulated twinaxial device EMLDEV Advanced Function Printing AFP > *YES AFP attachment AFPATTACH *WSC Port number PORT > 5001 (Note: Port number selected in step 1 above.) Switch setting SWTSET Local location address LOCADR Auxiliary printer AUXPRT Emulating ASCII device EMLASCII *NO Physical attachment ATTACH 8